A network technician incorrectly wired switch connections in your organization's network. It effectively disabled the switch as though it was a victim of denial of service attack. What should have be done to prevent this in the future? A. Install an IDS. B. Only use Layer 2 switches. C. Install SNMP on the switches. D. Implement STP or RSTP.

Question

Grady Sherman

Computers & Technology

10 September, 04:51

A network technician incorrectly wired switch connections in your organization's network. It effectively disabled the switch as though it was a victim of denial of service attack. What should have be done to prevent this in the future? A. Install an IDS. B. Only use Layer 2 switches. C. Install SNMP on the switches. D. Implement STP or RSTP.

+5

Answers (1)

Know the Answer?

Jaylyn Chavez · Answer 1

The answer is D. Implement STP or RSTP.

Explanation:

STP (Spanning Tree Protocol) was built to serve as a remedy for network issues. Existing before switches were developed, it works as a substitute for a switch when a switch is wired incorrectly (as seen in the question) or when it fails. STP has two roles:

To serve as an alternative when there is network failure or changes. To block out issues caused by loops on a network

RSTP (Rapid Spanning Tree Protocol) was built to optimize the standard STP. When there is a topology change, spanning tree convergence is much faster than the standard STP.

To prevent network failure in the future, STP or RSTP should be implemented.