03-05 / Fig (3) Shows T-Section of dimension 10x10x2cm

10 cm

2 cm

10 cm

2 cm

A: Find the location of center of gravity (N. A) of the given T-Section

Which of the following statements do not correctly describe pull manufacturing? (1). Material flow is determined by the need of the downstream workstation (2). Control is transferred from the beginning of the line to the end (3).

What is Pressure measured from absolute zero pressure called?

What design advantages can you identify in the location of the controller

When passing another vehicle, when is it acceptable to drive over the speed limit? A. When there's a broken yellow line next to you B. Under no circumstances C. When there's a broken white line next to you U D. If an emergency vehicle is behind you

A team of engineers has decided to design a new shoe for people suffering from a painful foot condition. Each of the following tasks is necessary for the engineers to undertake during the beginning phase of the project except which? A.

There are six items to be rung up in the cash register. The first item costs $15.00. Each item after that costs an additional $2.00. (item #2 costs $17, item #3 costs $19, etc.

List and briefly describe two modern's materials needs

Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.

How are fluids distributed and transported in a fluid power system?

The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.