Ask Question
EngineeringEngineering
31 August, 13:45

Draw and label the [100], [110] and [111] directions in a cubic unit cell

+4
Answers (1)
  1. 31 August, 14:14
    0
    Given that

    [100]:

    It means that y and z component is zero. It is only in x direction.

    [110]:

    This is in x-y plane. Because z - component is zero.

    [111]:

    This is in a space because it have all three directions.

    We take x is positive in right side, y is positive in upward direction and z is positive perpendicular to paper.

    The following diagram we can easily understand the following directions.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Draw and label the [100], [110] and [111] directions in a cubic unit cell ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A contractor needs to excavate 50,000 yd3 of silty clay and haul it with Caterpillar 69C dump trucks. Each truck can carry 30.9 yd3 of soil per load, and operates on a 15-minute cycle.
Answers (1)
Water at 120oC boils inside a channel with a flat surface measuring 45 cm x 45 cm. Air at 62 m/s and 20oC flows over the channel parallel to the surface. Determine the heat transfer rate to the air. Neglect wall thermal resistance.
Answers (1)
A piston-cylinder device contains 0.1 [kg] of air at a pressure of 100 [kPa] and a temperature of 400 [K] that undergoes an expansion process.
Answers (1)
A 1500-kg car travels on a level road at 42 m/s (State 1). It then continues down a hill to a lower part of the road (State 2), dropping in elevation by 25 meters in the process.
Answers (1)
Poor resistance to scoring in journal bearings is called: a) Fatigue resistance b) cohesive wear c) adhesive wear d) abrasive wear
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)
Home » Engineering » Draw and label the [100], [110] and [111] directions in a cubic unit cell
Sign Up Forgot Password?