A heat pump with refrigerant-134a as the working fluid is used to keep a space at 25°C by absorbing heat from geothermal water that enters the evaporator at 500C at a rate of 0.065 kg/s and leaves at 40°C. The refrigerant enters the evaporator at 20°C with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. The refrigerant loses 300 W of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 MPa at the same entropy as the inlet. Determine: (a) The degrees of subcooling of the refrigerant in the condenser, b) - The mass flow rate of the refrigerant. (c) The heating load and the COP of the pump, and d) - The theoretical minimum power input to the compressor for the same heating load.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “A heat pump with refrigerant-134a as the working fluid is used to keep a space at 25°C by absorbing heat from geothermal water that enters ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
What is torque and how does it work?
Answers (1)
Write a single 16-bit LC-3 instruction (in binary) that clears all the bits of R6 except the least significant two bits. In other words, after your instruction executes, bits 0 and 1 of R6 will be unchanged, and the rest of R6 will be zero.
Answers (1)
1. How many pieces of 12-1/2" long wood can be cut from a piece of wood that is 39-3/4" long? * o A. 2 o B. 3 o C. 6 OD. 7
Answers (1)
There are 10 vehicles in a queue when an attendant opens a toll booth. Vehicles arrive at the booth at a rate of 4 per minute. The attendant opens the booth and improves the service rate over time following the function u (t) = 1.1 +.
Answers (1)
Which of these sensors would be least likely used as an input sensor?
Answers (1)
New Questions in Engineering
There are six items to be rung up in the cash register. The first item costs $15.00. Each item after that costs an additional $2.00. (item #2 costs $17, item #3 costs $19, etc.
Answers (1)
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)