3. A storage tank is connected to a pond (at atmospheric pressure!) by a length of 4" pipe and a gate valve. From previous operating experience, it has been found that when the tank is at a pressure of 3 atm the flow through the pipe is 35 m3/h when the gate valve is fully open. If the pressure in the tank increases to 5 atm, what will be the maximum discharge rate from the tank?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “3. A storage tank is connected to a pond (at atmospheric pressure!) by a length of 4" pipe and a gate valve. From previous operating ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Which aluminum alloy would be a better choice for automobile sheet metal, considering this material will need to be formable into complex shapes, and may need to absorb the energy of a crash (AL 2024, 6061,7075)
Answers (1)
A 100-mm-diameter cast Iron shaft is acted upon by a 10 kN. m bending moment, a 8 kN. m torque, and a 150 kN axial force simultaneously.
Answers (1)
Air at 1 atm enters a thin-walled (5-mm diameter) long tube (2 m) at an inlet temperature of 100°C. A constant heat flux is applied to the air from the tube surface. The air mass flow rate is 140 * 10-6 kg/s.
Answers (1)
On a 2001 Honda Civic Brake Master Cylinder, what is the piston-to-pushrod clearance? a. 0-0.4 mm b. 0.5-0.7 mm c. 5-7 mm d. 0-4 mm
Answers (1)
The unit cost of natural gas ($/ft3) for residential customers is generally lower than that for the electric power industry. a) - True b) - False
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)