Which is NOT part of the clutch assembly?

Question 3 options:

A)

Engine crankshaft

B)

Release (throwout) bearing

C)

Flywheel

D)

Pressure plate

1. The AWS A5.5 is a list of electrodes used to weld which type of metal? A Copper and copper alloys. B. Carbon steels. C. Low alloy steels. D. Gray and ductile iron. E. Corrosion-resistant steels.

2 Consider airflow over a plate surface maintained at a temperature of 220°C. The temperature profile of the airflow is given as The airflow at 1 atm has a free stream velocity and temperature of 0.08 m/s and 20°C, respectively.

What are the principles involved in the process of sewage filtration?

In a manufacturing facility, 2-in-diameter brass balls (k = 64.1 Btu/h·ft·°F, rho = 532 lbm/ft^3, and cp = 0.092 Btu/lbm·°F) initially at 360°F are quenched in a water bath at 120°F for a period of 2 min at a rate of 120 balls per minute.

The 500-bed Lotta Hart Hospital has a small activated sludge plant to treat its wastewater. The average daily hospital discharge is 1,500 L per day per bed, and the average soluble BOD5 after primary settling is 500 mg/L.

List two characteristics of computers.

Which of the following elements of the CIA triad refers to maintaining and assuring the accuracy of data over its life-cycle? Confidentiality Integrity Availability Authentication

According to the video, what are some of the effects of the increase in the use of automated tools for Loading Machine Operators? Check all that apply.

A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.

An uncharged capacitor and a resistor are connected in series to a source of voltage. If the voltage = 7.41 Volts, C = 11.5 µFarad, and R = 89.