Joe wants to design a flashlight. Which consideration is most relevant for Joe to design it?

A.

portability

B.

environmental impact

C.

availability of materials

D.

durability

A product has a market estimate of 180,500 components and requires three processing steps (turning, milling, and drilling), having defective estimates of d1=0.06, d2=0.04, d3=0.01.

The fine for passing a stopped school bus illegally on the right is

Technician A says that excessive end play causes rapid wear of the sealing rings and possibly the sealing ring groove. Technician B says that seal does not rotate in the groove; therefore, the groove could not wear. Which technician is correct

After Hurricane Katrina there was considerable public outrage that many of the properties were not insured against flooding although they were insured against wind damage. What might explain these different approaches to insurance? A.

15.20 For each of the following pairs of polymers, do the following: (1) state whether it is possible to decide whether one polymer has a higher tensile strength than the other;

There are six items to be rung up in the cash register. The first item costs $15.00. Each item after that costs an additional $2.00. (item #2 costs $17, item #3 costs $19, etc.

List and briefly describe two modern's materials needs

Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.

How are fluids distributed and transported in a fluid power system?

The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.