What is the measure of electrical power or ability to do work?

A) Amp

B) Ohm

C) volt

D) Watt

A composite wall is to be used to insulate a freezer chamber at - 350C. Two insulating materials are to be used with conductivities of 0.04 W/mK and 0.1 W/mK. If the outside surface temperature of the inner layer (0.

g Write a program that takes in a positive integer as input, and outputs a string of 1's and 0's representing the integer in binary. For an integer x, the algorithm is:

The 10mm diameter rod is made of Kevlar 49. Determine the change in length and the change in diameter. Lenght of the rod = 100mm Therefore there are two 80KN forces are pulling the rod from both sides.

Wheel diameter = 150 mm, and infeed = 0.06 mm in a surface grinding operation. Wheel speed = 1600 m/min, work speed = 0.30 m/s, and crossfeed = 5 mm. The number of active grits per area of wheel surface = 50 grits/cm2.

1. Nitrogen at an initial state of 300 K, 150 kPa, and 0.2 m3 is compressed slowly in an isothermal process to a final pressure of 800 kPa. Determine the work done during this process.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both

What is the definition of diameter pitch?