Ask Question
EngineeringEngineering
27 June, 07:23

Describe electroplating as it would be used to batch process small components.

+1
Answers (1)
  1. 27 June, 07:34
    0
    Electroplating is the method of hydrolysis placing one layer of metal on another.

    Explanation:

    Electroplating is the method of hydrolysis placing one layer of metal on another, most frequently for ornamental reasons or to avoid metal deterioration due to corrosion. some precise electroplating are copper, silver and chromium plating are also available. Electroplating enables producers to utilize cheap metals like steel or zinc for the bulk of the item and then apply differently.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Describe electroplating as it would be used to batch process small components. ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Why is flexibility the most obvious benefit of road transportation select all that apply
Answers (1)
12-32 The Clear Brook High School band is holding a car wash as a fund-raiser to buy new equipment. The average time to wash a car is 4 minutes, and the time is exponentially distributed.
Answers (1)
liquid water enters a cooling tower operating at a steady state 40ºC with a mass flow rate of 105 kg/h. Cooled water at 25ºC exits the cooling tower at the same mass flow rate. Makeup water is supplied at 23ºC.
Answers (2)
Write a loop that prints each country's population in country_pop. Sample output for the given program with input 'China:1365830000, India:1247220000, United States:318463000, Indonesia:252164800': United States has 318463000 people.
Answers (1)
Motor control circuit conductors that extend beyond the motor control equipment enclosure shall have short- circuit and ground-fault protection sized not greater than percent of the value specified in Table 310.15 (B) (16) for 602 C conductors. O a.
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)
Home » Engineering » Describe electroplating as it would be used to batch process small components.
Sign Up Forgot Password?