Ask Question
EngineeringEngineering
9 December, 20:42

Injector orifice patterms and size will affect propellant mixing and distribution. a) - True b) - False

+5
Answers (1)
  1. 9 December, 21:00
    0
    Answer: True

    Explanation: Injector orifice is the factor which describes the size of the opening of the injector. There are different pattern and size of the opening for the injector which affects the mixture of the chemical substance that is used for the production of the energy that is known as propellant.

    The pattern and size of the orifice will define the variation in the amount of energy that could be produced. Thus the statement given is true.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Injector orifice patterms and size will affect propellant mixing and distribution. a) - True b) - False ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Show that the radius r of the orbit of a moon of a given planet can be determined from the radius R of the planet, the acceleration of gravity at the surface of the planet, and the time τ required by the moon to complete one full revolution about
Answers (1)
If a law enforcement officer stops a vehicle for a traffic violation and finds a front-seat passenger 18 years of age or older not wearing a safety belt, a safety belt violation will be charged to: The front-seat passenger Neither the driver nor the
Answers (1)
A turntable A is built into a stage for use in a theatrical production. It is observed during a rehearsal that a trunk B starts to slide on the turntable 10 s after the turntable begins to rotate.
Answers (1)
Care should be exercised when grinding and measuring the following on the Acme threading tool. Which is correct? A. Back rake, thread angle, and relief angles B. End flat width, relief angle, and thread angle C.
Answers (1)
The specifications of an electronic device are 24 / - 0.4 Amps. When the device exceeds specifications the average quality cost is $32.00. A sample of the devices had an average value of 23.9 Amps and a standard deviation of 0.211 Amps.
Answers (1)
New Questions in Engineering
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)
What is the definition of diameter pitch?
Answers (1)
Home » Engineering » Injector orifice patterms and size will affect propellant mixing and distribution. a) - True b) - False
Sign Up Forgot Password?