Explain the use of the Kanban system in a production line?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Explain the use of the Kanban system in a production line? ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
The stress is in the part working with static load. A. Dynamic stress B. Static stress or dynamic stre C. Static stress
Answers (1)
Why are dynamic heads greater than static heads? 1. Because static suction lifts are limited in vertical lift 2. Because the friction losses are always greater than the static heads 3. Because they are measured on the discharge side of the pump 4.
Answers (1)
A guy named Kirby Had touched only a gear on the projector. Yet there was a out of the blue rip. Kirby did not mind at all and started the projector. Things went wrong and the tape would not work. What ripped?
Answers (1)
At its current short-run level of production, a firm's average variable costs equal $20 per unit, and its average fixed costs equal $30 per unit. Its total costs at this production level equal $2,500. A. What is the firm's current output level? B.
Answers (2)
An engineer devises a scheme for extracting some power from waste process steam. The engineer claims that the steam enters the device at 340 F and quality 75%, and exits at 220 F and 65% quality.
Answers (1)
New Questions in Engineering
There are six items to be rung up in the cash register. The first item costs $15.00. Each item after that costs an additional $2.00. (item #2 costs $17, item #3 costs $19, etc.
Answers (1)
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)