If the channel-Length modulation effect is neglected, ID in the saturation region is considered to be independent of VDS

True

or

False

What is a motor cycle motor made out of

the frequencies 10, 12, 23 and 45 Hz. (a) What is the minimum sampling rate required to avoid aliasing? (b) If you sample at 40 sps, which frequency components will be aliased?

A long thin-walled double-pipe heat exchanger with tube and shell diameters of 1.0 cm and 2.5 cm, respectively, is used to condense refrigerant - 134a by water at 20°C.

How would your priorities change if the fine on the library book was $10 a day?

This code initially states that n=10 and f=n. Once the code enters the while loop, it stays in the while loop until the condition n>1 is not true. n is subtracted by 1 every iteration. This means that f = 10*9*8*7*6*4*3*2*1.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both

What is the definition of diameter pitch?