Sign In
Ask Question
Guest
Engineering
1 May, 07:34
What are the two reasons for a clear cut
+5
Answers (
1
)
Jeffrey
1 May, 08:03
0
to clear land for agriculture and settlement and to use or sell timber for lumber, paper products, or fuel.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Find an answer to your question 👍
“What are the two reasons for a clear cut ...”
in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Select the three branches of electrical engineering. Power and Lighting Cell Phones Electromagnetism Telecommunications Computer Engineering
Answers (1)
Three turbine generators of 20 MW capacity are supplying a load of 48 MW and the load suddenly increases to 50 MW. Two of the units are set with a speed droop of 9% and speed adjustment of 6%.
Answers (1)
A 25 kg iron block initially at 280°C is quenched in an insulated tank that contains 100 kg of water at 18°C. Assuming the water that vaporizes during the process condenses back in the tank, determine the total entropy change during this process.
Answers (1)
4. Porcelain enamel is sometimes referred to as A. "glass lining" B. kaolin C. vitreous enamel D. Both A and C.
Answers (1)
An automobile has a history of radiator leaks due to corrosion. The same car was found to have engine failure due to overheating that increased with the age of the vehicle. This is an example of: (a.) Classical component failure (b.
Answers (1)
New Questions in Engineering
The pressure and temperature at the beginning of compression of an air-standard Diesel cycle are95 kPa and 300 K, respectively. At the end of the heat addition, the pressure is 7.2 MPa and thetemperature is 2150 K.
Answers (1)
Explain two Types of bearing?
Answers (1)
7 Single-use earplugs require a professional fitting before they can be used. A True B) False
Answers (2)
Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.
Answers (1)
When the French horn plays with brass instruments, then it is played very softly to match the texture. True/False
Answers (1)
Home
»
Engineering
» What are the two reasons for a clear cut
Sign In
Sign Up
Forgot Password?