Ask Question
EngineeringEngineering
16 September, 11:25

What is the difference between geosynchronous and non-geosynchronous satellites? What are the pros and cons of these two types of satellites?

+1
Answers (1)
  1. 16 September, 11:31
    0
    Answer and Explanation:

    The difference between the geosynchronous and non-geosynchronous satellites is that the former is not bound to follow an inclined orbit whereas the latter is bound to be in inclined orbit.

    Some of the pros and cons of these two types of satellite:

    1. The orbital period of the former one is the same as that of the Earth, it moves in synchronization with the Earth.

    2. The geostationary satellites are used for various purposes like weather forecasting and communications at global level.

    3. Geostationary satellite results in parallax in the polar areas.

    4. Geostationary satellites, due to their positioning at higher altitudes results in signal delays.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “What is the difference between geosynchronous and non-geosynchronous satellites? What are the pros and cons of these two types of ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
What is the rms current flowing through a light bulb that uses an average power of 60.0 60.0 W when it is plugged into a wall receptacle supplying an rms voltage of 240.0 240.0 V?
Answers (1)
It is usually easy to minimize errors due to the input bias current of an opamp by adding a resistor in the input terminal, but this still leaves a small error due to the input offset current. Select one: True False
Answers (2)
What is the gear ratio required to drive a compressor at 150 cycles per second using a turbine that turns at 18,000 rpms?
Answers (1)
g The pump inlet is located 1 m above an arbitrary datum. The pressure and velocity at the inlet are 100 kPa and 2 m/s, respectively. The pump exit is located 4 m above the same datum. The pressure and velocity are 500 kPa and 3 m/s, respectively.
Answers (1)
Consider a standard room thermostat. Determine the sensor, transducer, output, and control stages for this measurement system.
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)
Home » Engineering » What is the difference between geosynchronous and non-geosynchronous satellites? What are the pros and cons of these two types of satellites?
Sign Up Forgot Password?