Ask Question
EngineeringEngineering
15 October, 01:51

Increasing rake angle will decrease the tendency for Built-Up-Edge to form. a) True b) False

+5
Answers (1)
  1. 15 October, 02:10
    0
    a) True

    Explanation:

    While machining of ductile material and high feed and low cutting speed welding action take place between tool material and chip material this welding action is called built up edge. Built up edge action takes place due to high temperature.

    To decrease the built up edge action

    1. Increase the rake angle.

    2. Increase the cutting speed

    3. Decrease the feed rate

    4. Use cutting fluid
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Increasing rake angle will decrease the tendency for Built-Up-Edge to form. a) True b) False ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A well-established way of power generation involves the utilization of geothermal energy-the energy of hot water that exists naturally underground - as the heat source.
Answers (1)
Which of these strategies can maximize insulation levels? Use of vacuum-insulation panels A. Adding rigid insulation outside of a stud wall to reduce thermal bridging B. Increasing insulation thickness C.
Answers (1)
When you first start a car after it has been sitting for more than an hour, it pollutes up to ... times more than when the engine is warm. 10 2 20 5
Answers (2)
1. In applying the superposition theorem, (a) all sources are considered simultaneously (b) all voltage sources are considered simultaneously (c) the sources are considered one at a time with all others replaced by a short (d) the sources are
Answers (2)
Both 1042 steel and 4340 steel are used commercially to make quenched round bars of about the same diameter, such as 1 in. Often, these are fully quenched.
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)
Home » Engineering » Increasing rake angle will decrease the tendency for Built-Up-Edge to form. a) True b) False
Sign Up Forgot Password?