If a tank can be pressurized to a maximum of 500 lb/in2 (psi), and the area is 20 in2. What is the most force that should be exerted by the system?

A) 25 lbs

B) 10,000 lbs

C) 250 lbs

D) 1000 lbs

Show that the radius r of the orbit of a moon of a given planet can be determined from the radius R of the planet, the acceleration of gravity at the surface of the planet, and the time τ required by the moon to complete one full revolution about

If a law enforcement officer stops a vehicle for a traffic violation and finds a front-seat passenger 18 years of age or older not wearing a safety belt, a safety belt violation will be charged to: The front-seat passenger Neither the driver nor the

A turntable A is built into a stage for use in a theatrical production. It is observed during a rehearsal that a trunk B starts to slide on the turntable 10 s after the turntable begins to rotate.

Care should be exercised when grinding and measuring the following on the Acme threading tool. Which is correct? A. Back rake, thread angle, and relief angles B. End flat width, relief angle, and thread angle C.

The specifications of an electronic device are 24 / - 0.4 Amps. When the device exceeds specifications the average quality cost is $32.00. A sample of the devices had an average value of 23.9 Amps and a standard deviation of 0.211 Amps.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both

What is the definition of diameter pitch?