When discussing universal joints,
Technician A says that they eliminate vibrations caused by the power pulses of
the engine.
Technician B says that they allow the drive shaft to change angles in response
to movements of the car's suspension and rear axle assembly.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “When discussing universal joints, Technician A says that they eliminate vibrations caused by the power pulses of the engine. Technician B ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Which statements describe codominance? Select three options. Traits are usually dominant. Traits are neither dominant nor recessive. Offspring exhibit an intermediate form of alleles from the parents.
Answers (2)
A vertical piston-cylinder device contains water and is being heated on top of a range. During the process, 10 kJ of heat is transferred to the water, and heat losses from the side walls amount to 80 J.
Answers (1)
Your organization spans multiple geographical locations. The name resolution is happening with a single DNS zone for the entire organization. Which of the following is likely to happen if you continue with the single DNS zone? [Choose all that apply.
Answers (1)
Describe the key components of a servo motor? How is continuous motion servo different than standard servo?
Answers (1)
How do you connect several springs to increase the equivalent stiffness? What is one example from industry or other real-life situations where this occurs?
Answers (1)
New Questions in Engineering
List two characteristics of computers.
Answers (1)
Which of the following elements of the CIA triad refers to maintaining and assuring the accuracy of data over its life-cycle? Confidentiality Integrity Availability Authentication
Answers (1)
According to the video, what are some of the effects of the increase in the use of automated tools for Loading Machine Operators? Check all that apply.
Answers (2)
A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.
Answers (1)
An uncharged capacitor and a resistor are connected in series to a source of voltage. If the voltage = 7.41 Volts, C = 11.5 µFarad, and R = 89.
Answers (1)