Sign In
Ask Question
Dana Walsh
Engineering
18 August, 23:58
What is the no-slip condition? What causes it?
+5
Answers (
2
)
Kenzie
19 August, 00:18
0
The no-slip condition is the viscosity of a fluid. This is most likely brought on by stress or stressful situations.
Comment
Complaint
Link
Valentin Melendez
19 August, 00:28
0
The no-slip condition for viscous fluids assumes that at a solid boundary, the fluid will have zero velocity relative to the boundary. Along with a flow when adhesion is stronger than cohesion ... Basically the molecules of the fluid crash into the molecules of the wall and get stopped.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Find an answer to your question 👍
“What is the no-slip condition? What causes it? ...”
in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Define a tolerance and list three possible sources
Answers (1)
In Florida the fine for going over 5 mph in a school zone results in a fine of how much
Answers (2)
In an aligned and continuous glass fiber-reinforced nylon 6,6 composite, the fibers are to carry 94 % of a load applied in the longitudinal direction. Modulus of Elasticity [GPa (psi) ] Tensile Strength [MPa (psi) ] Glass fiber 72.5 (10.
Answers (1)
What is the atmospheric temperature on Venus if the density is 67 kg/m^3 and the pressure is 9.3 mPa, absolute? Express in °C and °F. The atmosphere is composed of CO2.
Answers (1)
Consider a very long, cylindrical fin. The temperature of the fin at the tip and base are 25 °C and 50 °C, respectively. The diameter of the fin is 3 cm. The thermal conductivity of the fin is 150 W/m·K. The heat transfer coefficient is 123 W/m2·K.
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)
Home
»
Engineering
» What is the no-slip condition? What causes it?
Sign In
Sign Up
Forgot Password?