in the verification of Ohm's law mass is 200 g initial length is 31 final length is 31.6 so what is the Extension?

During an actual run with the calorimeter, there are two important criteria which must be satisfied by a correctly positioned thermometer. What are these two criteria?

Suppose you have two boxes in front of you. One box contains a Thevenin Equivalent (voltage source in series with a resistor) and the other box contains a Norton Equivalent (current source in parallel with a resistor).

A walrus loses heat by conduction through its blubber at the rate of 220 W when immersed in - 1.00°C water. Its internal core temperature is 37.0°C, and it has a surface area of 2.23 m2.

The pressure gauge on the steam condenser for a turbine indicates 66.5 mm Hg of vacuum. The barometer reading for the local atmospheric pressure is 755 mm Hg. What is the pressure in the condenser in psia g

Compare the specific fuel consumption of a turbojet and a ramjet that are being considered for flight at M = 1.5 and 50,000 ft altitude (ambient pressure and temperature: 11.6 kPa and 205 K, respectively).

How are fluids distributed and transported in a fluid power system?

The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.

Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers

What advantage might there be to having the encoder located on the motor side of the gearhead instead of at the output shaft of the gearhead (in other words so that it would rotate at the speed of the armature rather than at the speed of the output

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a) - conduction b) - convection c) - radiation d) - conduction and convection