What is the definition of a fluid?

What are the factors of production in business? Land, labor, and capital land, capital, and interest land, labor, and customer base capital, customer base, and interest

3. Technician A says that on-board self-diagnostics test mode procedures should be conducted on a cold engine. Technician B says that many diagnostic trouble codes (DTCs) will monitor items only when the engine control system is in closed loop.

What changes would you make to the experiment, to improve the efficiency of this system?

You are asked to look into adding a circuit for a new pump in a hydraulics lab. After some investigation of the electrical service in the building you find that there are a few voltage options; 120V, single-phase; 208V, single-phase; 208V, 3-phase.

The heat rate is essentially the reciprocal of the thermal efficiency. a) - True b) - False

The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both