Ask Question
EngineeringEngineering
6 September, 22:20

What are the two types of chatter (vibration) in metal cutting operations?

+5
Answers (1)
  1. 6 September, 22:46
    0
    Forced vibrations and self-generated vibrations

    Explanation:

    Forced vibration is caused due to the motion of the cutting operation itself it is common in operations that have interrupted cutting like milling.

    The size of the chips are related to self-generated vibrations. If larger chips are formed this means higher depth of cut is given. If smaller chips are formed this means lower depth of cut is given. When we give excess depth of cut then self-generated vibrations are produced.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “What are the two types of chatter (vibration) in metal cutting operations? ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Which part does NOT rotate when the engine is running and the clutch pedal is depressed? Question 4 options: A) Pressure plate B) Clutch disc C) Flywheel D) Pilot bearing
Answers (1)
The mechanical properties of a metal may be improved by incorporating fine particles of its oxide. Given that the moduli of elasticity of the metal and oxide are, respectively, 60 GPa and 380 GPa, what is the (a) upper-bound, and (b) lower-bound
Answers (1)
What are the two types of pumps in compressors?
Answers (2)
Summering Kirchhoffs current law in your own words
Answers (1)
What size wire would you use to wire a motor that draws 16 A from a circuit?
Answers (1)
New Questions in Engineering
Which of the following elements of the CIA triad refers to maintaining and assuring the accuracy of data over its life-cycle? Confidentiality Integrity Availability Authentication
Answers (1)
According to the video, what are some of the effects of the increase in the use of automated tools for Loading Machine Operators? Check all that apply.
Answers (2)
A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.
Answers (1)
An uncharged capacitor and a resistor are connected in series to a source of voltage. If the voltage = 7.41 Volts, C = 11.5 µFarad, and R = 89.
Answers (1)
The convection heat transfer coefficient for a clothed person standing in moving air is expressed as h 5 14.8V0.69 for 0.15, V, 1.5 m/s, where V is the air velocity. For a person with a body surface area of 1.
Answers (1)
Home » Engineering » What are the two types of chatter (vibration) in metal cutting operations?
Sign Up Forgot Password?