The yield strength for an alloy that has an average grain diameter of 5.3 x 10-2 mm is 121 MPa. At a grain diameter of 8.0 x 10-3 mm, the yield strength increases to 233 MPa. At what grain diameter, in mm, will the yield strength be 209 MPa?

Match the car part to the system Catalytic Converter Radiator Alternator Shock absorbers Engine And Suspension system Cooling system Electrical system Power train Exhaust system

There are many diferent materials available for seal faces. List the following seal face materials in order of hardness. i. e Hardest first, softest last.

If, when a relay is energized, you measure 0.05 VAC across a set of normally open contacts, the A. relay is operating properly B. contacts must be burnt C. contacts must be pitted D. coil is open

A rigid, sealed cylinder initially contains 100 lbm of water at 70 °F and atmospheric pressure. Determine: a) the volume of the tank (ft3). Later, a pump is used to extract 10 lbm of water from the cylinder.

If a ship floating in the ocean weighs 1 million metric tons, approximately what volume of water does it displace? a. 1 million cubic meters b. 1 million cubic centimeters C. 1 million liters d.

List and briefly describe two modern's materials needs

Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.

How are fluids distributed and transported in a fluid power system?

The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.

Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers