Sign In
Ask Question
Darrell Conrad
Engineering
3 June, 04:53
The molecular weight of a 10g rubber band
+2
Answers (
1
)
Brooklyn Mclaughlin
3 June, 05:03
0
The answer to this question is 1 * 10g / mole = 10
Explanation:
From the question given, the first step to take is to find the weight of a 10g rubber band.
Now,
The molecular weight of rubber band, tires the primary chains may have molecular weights is of order of 1 x 10 g/
Therefore it is 1 * 10g/mole = 10
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Find an answer to your question 👍
“The molecular weight of a 10g rubber band ...”
in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A solid titanium alloy [G 114 GPa] shaft that is 720 mm long will be subjected to a pure torque of T 155 N m. Determine the minimum diameter required if the shear stress must not exceed 150 MPa and the angle of twist must not exceed 7 degree.
Answers (1)
You should check your tire pressure
Answers (1)
Fluid originally flows through a tube at a rate of 100 cm^3/s. To illustrate the sensitivity of the Poiseuille flow rate to various factors, calculate the new flow rate for the following changes with all other factors remaining the same as in the
Answers (1)
How can you tell if your car is overheating? A. Your temperature gauge is moving into the red or "H" zone. B. Your temperature gauge is moving into the blue or "C" zone. C. You physically feel your car is getting hot. D.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)
Home
»
Engineering
» The molecular weight of a 10g rubber band
Sign In
Sign Up
Forgot Password?