Engineering

30 April, 05:48

Water flows steadily through a section of piping in a heat exchanger at a constant pressure of 1.5 bar, entering as a vapor and exiting as a liquid. One side of the pipe is maintained at 400K and receives 20 kJ/s of energy by heat transfer, while the other side of the pipe is maintained at 800K and rejects 40 kJ/s of energy by heat transfer. Is this process possible, impossible, or indeterminate from the information given

+1

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question 👍 “Water flows steadily through a section of piping in a heat exchanger at a constant pressure of 1.5 bar, entering as a vapor and exiting as ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.

Search for Other Answers

You Might be Interested in

What different between 'flow analysis using control volume method' and 'flow analysis using differential method'?

Which parameters affect the overall heat transfer coefficient in a heat exchanger?

Description: Write a function that takes in a list of numbers and a list of indices. Note that indexList may not only contain valid indices. The function should keep track of the number and type of errors that occur.

For an open channel with a given slope, if the roughness is decreased a. The flow rate in the channel will increase b. The flow rate in the channel will remain the same c. The flow rate in the channel will decrease

Gear A has 30 teeth & Gear B has 20 teeth. If Gear A rotates at 1000rpm, what speed does Gear B rotate at?

New Questions in Engineering

The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both