A shunt regulator utilizing a zener diode with an incremental resistance of 8 is fed through an 82 - resistor. If the raw supply changes by 1.0 V, what is the corresponding change in the regulated output voltage
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “A shunt regulator utilizing a zener diode with an incremental resistance of 8 is fed through an 82 - resistor. If the raw supply changes by ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A rear wheel drive car of mass 1000 kg is accelerating with a constant acceleration without slipping from 0 to 60 m/s in 1 min. What will be friction force acting on each rear wheel of the car? (a) - 1000 N (b) - 60000N (c) - 30000N (d) - 500N
Answers (1)
While discussing electrical relays: Technician A says that the relay's coil is energized when the circuit's control switch is open. This action connects power to the load circuit.
Answers (2)
How does the invention of electrical lights and automobiles impact the world today? Explain. (1 paragraph minimum)
Answers (1)
A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at T[infinity] = 15°C.
Answers (1)
A 25 kg iron block initially at 280°C is quenched in an insulated tank that contains 100 kg of water at 18°C. Assuming the water that vaporizes during the process condenses back in the tank, determine the total entropy change during this process.
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)