A rectangular cross section bar of 4140 steel (10 mm x 40 mm) experiences an axial compressive load of 159.5 kN. What is the measurement of the longer edge of the rectangular cross section under this load?

Estimate the theoretical fracture strength (in MPa) of a brittle material if it is known that fracture occurs by the propagation of an elliptically shaped internal crack of length 0.25 mm that has a tip radius of curvature of 0.

If 6 men or 8 women can finish a work in 12 days, 9 men and 12 women will finish the work nearly?

Print "userNum1 is negative." if userNum1 is less than 0. End with newline. Assign userNum2 with 2 if userNum2 is greater than 10. Otherwise, print "userNum2 is less or equal 10.". End with newline.

Write the equation for the output voltage as a function of the input voltage (sketch a circuit defining your variables). The maximum current coming out/into the op-amp output (terminal 6) is approximately 20 mA.

Justify with proper description why low cost automation is required to improve productivity in small scale industries. List out some examples.

The input power for a thermostat is wired to the A. R b. G c. W d. Y

What standard feature is on all circular saws? 1. Blade guard 2. Blade-height adjustment 3. Angle-of-cut adjustment 4. All of the above

Write a program that prints, line by line, the numbers from 1 to 100. For multiples of three print the word "Cow" instead of the number and for the multiples of seven print "Pie" instead of the number.

Always refill your gas tank well before A. You reach your destination B. Your indicator light goes on C. Your fuel gauge reaches half empty D. Your fuel gauge reaches one-quarter full

A car is towed into a shop with a no-start problem. The engine cranks but will not fire and run on its own power. The car has a throttle body, fuel injected gasoline engine. Technician (A) says to check for spark and fuel first.