Sign In
Ask Question
Kaylie Clarke
Engineering
19 April, 03:03
Internal and external flow boiling regimes?
+3
Answers (
1
)
Caden Owen
19 April, 03:12
0
The flow boiling is also classified as either external and internal flow boiling depending on whether the fluid is forced to flow over a heated surface or inside a heated channel. The two-phase flow in a tube exhibits different flow boiling regimes, depending on the relative amounts of the liquid and the vapor phases.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Find an answer to your question 👍
“Internal and external flow boiling regimes? ...”
in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
The specific volume of water vapor at 0.3 MPa, 160°C is 0.651 m3/kg. If the water vapor occupies a volume of 1.2 m3, determine the amount present, in kg.
Answers (1)
Why does electrical power need to be used as it is created?
Answers (2)
If, when a relay is energized, you measure 0.05 VAC across a set of normally open contacts, the A. relay is operating properly B. contacts must be burnt C. contacts must be pitted D. coil is open
Answers (1)
A wooden cylinder (0 02 x 0 02 x 0 1m) floats vertically in water with one-third of ts length immersed.
Answers (1)
6. Staples are the most common item used to secure and support cables in residential wiring.
Answers (1)
New Questions in Engineering
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)
What is the definition of diameter pitch?
Answers (1)
Home
»
Engineering
» Internal and external flow boiling regimes?
Sign In
Sign Up
Forgot Password?