A voltage regulator is to provide a constant DC voltage Vl=10V to a load Rl from a nominal Vcc=15V supply voltage. The load can vary from 20Ω to 1KΩ. The supply voltage Vcc can vary from 13V to 16V. The op-amp can provide a maximum output current of 20mA. a) Find the βnecessary for the transistor to provide the needed current. b) Find the maximum power the transistor must dissipate.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “A voltage regulator is to provide a constant DC voltage Vl=10V to a load Rl from a nominal Vcc=15V supply voltage. The load can vary from ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Determine the temperature, in K, of 5 kg of air at a pressure of 0.3 MPa and a volume of 2.2 m3. Ideal gas behavior can be assumed for air under these conditions.
Answers (1)
A worker standing on a freshly mopped floor is adjusting products on a metal shelf. There is an exposed wire in contact with the shelving. What i this an example of? Select the best option.
Answers (1)
Describe what a dislocation is, and how it is important in the plastic deformation of materials
Answers (1)
he efficiency of a steam power plant can be increased by bleeding off some of the steam that would normally enter the turbine and usingit to preheat the water entering the boiler.
Answers (1)
Liquid benzene and liquid n-hexane are blended to form a stream flowing at a rate of 1700 lbm/h. An on-line densitometer (an instrument used to determine density) indicates that the stream has a density of 0.810 g/mL.
Answers (1)
New Questions in Engineering
Which of the following should NOT be done to keep people from slipping on floors?
Answers (2)
1. What types of fire can plain water be used on?
Answers (2)
Pressurized steam at 400 K flows through a long, thin-walled pipe of 0.6-m diameter. The pipe is enclosed in a concrete (stone mix) casing that is of square cross section and 1.75 m on a side.
Answers (1)
If traffic is approaching on your left and there is a child riding a bike to your right, you should: A. Move closer to oncoming traffic B. Move closer to the bicyclist C. Pull over until the road is clearer
Answers (1)
Alloy parts were cast with a sand mold that took 160 secs for a cube-shaped casting to solidify. The cube was 50 mm on a side. (a) Determine the value of the Chvorinov's mold constant.
Answers (1)