Assume that one component with 256 I/Os is offered in three forms: QFP, full array PBGA, and fl ip chip with gold bumps. The pitch of the QFP is 0.4 mm and the lead length is 1 mm. An edge of the QFP to the center of the nearest lead is assumed to the same as the lead pitch. The pitch of the BGA is 1.27mm and an edge to the center of the nearest solder joints is 2.5 mm. The pitch of the flip chip is 0.4 mm and an edge to the center of the nearest solder joints is1mm. Assume the underll extension is 1 mm.
1. Calculate the PCB surface area requirement for each case.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Assume that one component with 256 I/Os is offered in three forms: QFP, full array PBGA, and fl ip chip with gold bumps. The pitch of the ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
3. Technician A says that on-board self-diagnostics test mode procedures should be conducted on a cold engine. Technician B says that many diagnostic trouble codes (DTCs) will monitor items only when the engine control system is in closed loop.
Answers (1)
a metal coin has certain properties that can be measured. which property of a coin is different on the moon that is on earth?
Answers (1)
What gage pressure does a skin diver experience when they dive to 35 ft in the ocean with a water temperature of 55 °F? Report your answer in lbf/in^2.
Answers (1)
The concrete canoe team does some analysis on their design and calculates that they need a compressive strength of 860 psi. They test several mix designs and chose one that has a sample mean of 900 psi with a standard error of the mean of 10 psi.
Answers (1)
Two gage marks are placed exactly 250 mm apart on a 12-mm-diameter aluminum rod with E 5 73 GPa and an ultimate strength of 140 MPa. Knowing that the distance between the gage marks is 250.
Answers (1)
New Questions in Engineering
The pressure and temperature at the beginning of compression of an air-standard Diesel cycle are95 kPa and 300 K, respectively. At the end of the heat addition, the pressure is 7.2 MPa and thetemperature is 2150 K.
Answers (1)
Explain two Types of bearing?
Answers (1)
7 Single-use earplugs require a professional fitting before they can be used. A True B) False
Answers (2)
Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.
Answers (1)
When the French horn plays with brass instruments, then it is played very softly to match the texture. True/False
Answers (1)