Engineering

24 June, 18:02

What purpose does the case of a rifle or handgun cartridge serve? A, To hold all of its components together To hold all of its components together B, To create enough pressure to propel the bullet To create enough pressure to propel the bullet C, To serve as the projectile To serve as the projectile D, To control the spread of the shot To control the spread of the shot

+2

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question 👍 “What purpose does the case of a rifle or handgun cartridge serve? A, To hold all of its components together To hold all of its components ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.

Search for Other Answers

You Might be Interested in

What is the measure of electrical power or ability to do work? A) Amp B) Ohm C) volt D) Watt

Considering a closed, stationary, rigid container with certain gas inside, the total mass of the gas is 2 kg, and a heating process goes from state 1 with internal energy 100 kJ/kg to state 2 with internal energy 200 kJ/kg.

What other stuff did percy spencer invent

Use Newton's method to determine the angle θ, between 0 and π/2 accurate to six decimal places. for which sin (θ) = 0.1. Show your work until you start computing x1, etc. Then just write down what your calculator gives you.

Assign numMatches with the number of elements in userValues that equal matchValue. userValues has NUM_VALS elements. Ex: If userValues is {2, 1, 2, 2} and matchValue is 2, then numMatches should be 3.

New Questions in Engineering

The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both