Ask Question
EngineeringEngineering
5 May, 21:01

What is the difference Plastic vs elastic deformation.

+5
Answers (1)
  1. 5 May, 21:25
    0
    What is the difference Plastic vs elastic deformation

    Explanation:

    The elastic deformation occurs when a low stress is apply over a metal or metal structure, in this process, the stress' deformation is temporary and it's recover after the stress is removed. In other words, this DOES NOT affects the atoms separation.

    The plastic deformation occurs when the stress apply over the metal or metal structure is sufficient to deform the atomic structure making the atoms split, this is a crystal separation on a limited amount of atoms' bonds.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “What is the difference Plastic vs elastic deformation. ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
When was Lamborghini's Made A.) 2004 B.) 1963 C.) 1923 D.) 1990
Answers (1)
A Vector is a quantity that has magnitude, direction, and sense. a) - True b) - False
Answers (1)
A developer wants to build a residential/commercial project. What would be a likely initial step in determining its feasibility?
Answers (1)
To water his lawn, a homeowner uses two hoses. One connects to the faucet, the other to the end of the first hose to make the hose longer. Each hose is three meters long, but one has 20-mm diameter, the other has 40-mm diameter.
Answers (1)
What's the monomer? Show the structure.
Answers (1)
New Questions in Engineering
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)
What advantage might there be to having the encoder located on the motor side of the gearhead instead of at the output shaft of the gearhead (in other words so that it would rotate at the speed of the armature rather than at the speed of the output
Answers (1)
Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a) - conduction b) - convection c) - radiation d) - conduction and convection
Answers (2)
Home » Engineering » What is the difference Plastic vs elastic deformation.
Sign Up Forgot Password?