Ask Question
EngineeringEngineering
8 April, 22:06

1. Which of the following is the ideal way to apply pressure onto pedals?

A. With your entire body weight behind it

B. Gently at first and then with full force

C. Stomping with force, so it reacts

D. By pressing gradually

+1
Answers (2)
  1. 8 April, 22:12
    0
    D. By pressing gradually

    Explanation:

    When driving, the ideal way to apply pressure onto pedals is by pressing gradually as when you press the pedal more fuel goes into the engine and the speed of the car increases. Because of that, when you are driving it is better to have a steady increase in the pressure because that allows you to maintain the control of the car and avoid risky situations.
  2. 8 April, 22:31
    0
    I think D. By pressing gradually
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “1. Which of the following is the ideal way to apply pressure onto pedals? A. With your entire body weight behind it B. Gently at first and ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
While having a discussion about O-rings at the bottom of filters, Technician A says that the Automotive Filter Manufacturers Council recommends that the filter O-ring be lubricated with oil after installing the filter.
Answers (1)
Problem 2 (a) A sinusoid with a frequency of 2Hz is applied to a sampler/zero-order hold combination. The sampling rate is 10Hz. List all the frequencies present in the output that are less than 50Hz.
Answers (1)
You test the lighting for the first time none of the new lights work, but the old ones do. What should you do first?
Answers (2)
Consider a standard room thermostat. Determine the sensor, transducer, output, and control stages for this measurement system.
Answers (1)
Calculate the planar area of a rectangular wing with a span of 0.225 m and a chord of 0.045 m.
Answers (2)
New Questions in Engineering
The pressure and temperature at the beginning of compression of an air-standard Diesel cycle are95 kPa and 300 K, respectively. At the end of the heat addition, the pressure is 7.2 MPa and thetemperature is 2150 K.
Answers (1)
Explain two Types of bearing?
Answers (1)
7 Single-use earplugs require a professional fitting before they can be used. A True B) False
Answers (2)
Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.
Answers (1)
When the French horn plays with brass instruments, then it is played very softly to match the texture. True/False
Answers (1)
Home » Engineering » 1. Which of the following is the ideal way to apply pressure onto pedals? A. With your entire body weight behind it B. Gently at first and then with full force C. Stomping with force, so it reacts D. By pressing gradually
Sign Up Forgot Password?