Ask Question
20 November, 17:08

Part A Engineering stress and strain are calculated using the actual cross-sectional area and length of the specimen. True or false?

+2
Answers (2)
  1. 20 November, 17:28
    0
    Answer: True

    Explanation:

    Engineering stress is the applied load divided by the original cross-sectional area of a material. It is also known as nominal stress. It can also be defined as the force per unit area of a material. Engineering Stress is usually in large numbers.

    While Engineering strain is the amount that a material deforms per unit length in a tensile test. It can also be defined as extension per unit length. It has no unit as it is a ratio of lengths. Engineering Strain is in small numbers.
  2. 20 November, 17:32
    0
    False

    Explanation:

    Engineering stress and strain are calculated utilizing the original gauge lengths and original area.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Part A Engineering stress and strain are calculated using the actual cross-sectional area and length of the specimen. True or false? ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers