Ask Question
EngineeringEngineering
27 September, 12:50

What is the initial state of the compression process of your car?

+2
Answers (1)
  1. 27 September, 13:10
    0
    if the car used petrol as fuel, then first air will mix with fuel inside the carburetor and then it will allow to go inside the engine cylinder. Inside the engine cylinder, in the first process it will compress the mixture of air and fuel up to 9 to 10 compression ratio. After that heat addition will take place at constant volume and temperature of mixture will increase. After this the mixture will allow to expand inside the cylinder and it will give the power of crank shaft. And the last stage exhaust process take place in which flue gas comes out from cylinder.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “What is the initial state of the compression process of your car? ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A rear wheel drive car of mass 1000 kg is accelerating with a constant acceleration without slipping from 0 to 60 m/s in 1 min. What will be friction force acting on each rear wheel of the car? (a) - 1000 N (b) - 60000N (c) - 30000N (d) - 500N
Answers (1)
While discussing electrical relays: Technician A says that the relay's coil is energized when the circuit's control switch is open. This action connects power to the load circuit.
Answers (2)
How does the invention of electrical lights and automobiles impact the world today? Explain. (1 paragraph minimum)
Answers (1)
A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at T[infinity] = 15°C.
Answers (1)
A 25 kg iron block initially at 280°C is quenched in an insulated tank that contains 100 kg of water at 18°C. Assuming the water that vaporizes during the process condenses back in the tank, determine the total entropy change during this process.
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)
Home » Engineering » What is the initial state of the compression process of your car?
Sign Up Forgot Password?