Ask Question
EngineeringEngineering
11 February, 11:45

Rolling and Shearing are the types of a) - Bulk Deformation Process b) - Sheet Metal Process c) - Machining Process d) - Both a & c d) - None of them

+3
Answers (1)
  1. 11 February, 12:03
    0
    a) Bulk deformation process

    Explanation:

    Rolling

    Rolling is a metal forming process. In rolling work piece passes through two moving rollers and get compressed. in rolling thickness of work piece will reduces and length of work piece will increase for maintaining the constant area. Due to compression bulk deformation takes place.

    Shearing

    In shearing one surface slides on another surface and deformation take place. shearing is a machining process. This is also a bilk motion deformation process.

    So from above we can say that option a is right.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Rolling and Shearing are the types of a) - Bulk Deformation Process b) - Sheet Metal Process c) - Machining Process d) - Both a & c d) - ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A structural component is fabricated from an alloy that has a plane-strain fracture toughness of 62 MPa√m. It has been determined that this component fails at a stress of 250 MPa when the maximum length of an internal crack is 1.6 mm.
Answers (1)
Create an application named NumbersDemo whose main () method holds two integer variables. Assign values to the variables. In turn, pass each value to methods named displayTwiceTheNumber (), displayNumberPlusFive (), and displayNumberSquared ().
Answers (1)
Consider a standard room thermostat. Determine the sensor, transducer, output, and control stages for this measurement system.
Answers (1)
Describe an E2 mechanism A. Not stereospecific and not concerted B. Stereospecific and not concerted C. Stereospecific and concerted D. Not stereospecific and concerted
Answers (1)
A large fraction of the thermal energy generated in the engine of a car is rejected to the air by the radiator through the circulating water. Should the radiator be analyzed as an open system?
Answers (1)
New Questions in Engineering
Which of the following describes a logic bomb? a rogue piece of code in a system activates on a certain date a piece of code replaces the boot instructions the cookie tracker is exploited to note your browsing habits a piece of code hidden in a
Answers (1)
Supercharging is the process of (a) Supplying the intake of an engine with air at a density greater than the density of the surrounding atmosphere (b) providing forced cooling air (e) injecting excess fuel for raising more load (d) supplying
Answers (1)
Laws that protect businesses involve
Answers (1)
What are the three basic components of a limit switch
Answers (1)
If a law enforcement officer stops a vehicle for a traffic violation and finds a front-seat passenger 18 years of age or older not wearing a safety belt, a safety belt violation will be charged to: The front-seat passenger Neither the driver nor the
Answers (1)
Home » Engineering » Rolling and Shearing are the types of a) - Bulk Deformation Process b) - Sheet Metal Process c) - Machining Process d) - Both a & c d) - None of them
Sign Up Forgot Password?