Compute the longitudinal modulus of elasticity (in GPa) for a continuous and aligned hybrid composite consisting of aramid and glass fibers in volume fractions of 0.22 and 0.30, respectively, within a polyester resin matrix, given the following dа ta:
Modulus of Elasticity:
(GPa)
Glass fibers 72.5
Aramid fibers 131
Polyester 2.5
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Compute the longitudinal modulus of elasticity (in GPa) for a continuous and aligned hybrid composite consisting of aramid and glass fibers ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A mass is dropped (i. e., initial v=0) from the top of a tall building at a height of 300 m. If we neglect air friction, find the velocity of the object when it hits the ground (m/s). g = 9.8 m/s^2
Answers (1)
What is the composition of the two phases that form when a stream of 40% A, 39% B, and 21% C separates into two phases? Label the phases as A-rich or C-rich. Is there more of the A-rich or C-rich phase?
Answers (1)
A contractor needs to excavate 50,000 yd3 of silty clay and haul it with Caterpillar 69C dump trucks. Each truck can carry 30.9 yd3 of soil per load, and operates on a 15-minute cycle.
Answers (1)
Air enters a 30-cm-diameter cooling section at 1 atm, 35°C, and 45 percent relative humidity at 18 m/s. Heat is removed from the air at a rate of 750 kJ/min.
Answers (1)
Rubber mallets only come in a white rubber true or false?
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)