Engineering » Page 82

Dominique Carter

Engineering

Does the army good 4 you

Answer Answers (1)

Sebastian Collier

Engineering

Calculate how large a mass would be necessary to obtain a mechanical noise limit of [Equation] = 1 nG, 1 µG, and 1 mG if the mechanical resonance frequency is [Equation] = 100 Hz. If the mass is to be made of cube of 'silicon, what would its physical dimensions be?

Answer Answers (1)

Engineering

A resistor with the color bands brown, red, red and silver will have a resistance of a. 120 ohms b. 1200 ohms C. 2100 D. 6,400

Answer Answers (2)

Engineering

The construction time for a bridge is weather dependent. The project is expected to take 150 days if the weather is dry and hot. If the weather is damp and cool, it is expected to take 350 days. Otherwise, it is expected to take 300 days. Historical data suggests that there is a 40% chance of cool damp weather and a 10% chance of hot dry weather. What is the expected completion time of the project? g

Answer Answers (1)

Engineering

The total process of quality control is best described by what

Answer Answers (1)

Moses Contreras

Engineering

You are a part of the team that is creating the process routing for a new product. Which of the following information is NOT necessary to include in the process routing?

Answer Answers (1)

Mohammad Porter

Engineering

How do you get the fortnite launcher off your hard drive?

Answer Answers (1)

Engineering

A torsion member has an elliptical cross section with major and minor dimensions of 50.0 mm and 30.0 mm, respectively. The yield stress of the material in the torsion member is Y=400 MPa. Determine the maximum torque that can be applied to the tension member based on a factor of safety 1.85 using the maximum shear stress criterion of failure.

Answer Answers (1)

Engineering

Many radios can be operated either by plugging them into the wall or by using batteries. How can a radio use either source of current?

Answer Answers (1)

Engineering

Establishes general guidelines concerning licensing and vehicle

10. The

registration.

A. National Highway Safety Act

B. National Traffic and Motor Vehicle Safety Act

C. Uniform Traffic Control Devices Act

Answer Answers (1)

Engineering

For goods-producing firms, at which of the following levels of resource planning does scheduling for individual subassemblies and resources by week and day take place?

Answer Answers (1)

Jordin Mcdaniel

Engineering

You need a replace () method that will take in two parameters, the character to be replaced and the sequence of characters to replace it with. This method will use StringBuilder methods and logic to change all occurrences of the original string to a new string, while still preserving a copy of the original string.

Answer Answers (1)

Engineering

The distribution of actual weights of 8‑ounce wedges of cheddar cheese produced at a dairy is Normal, with mean 8.1 ounces and standard deviation 0.2 ounces. A sample of 10 of these cheese wedges is selected. The distribution of the sample mean of the weights of cheese wedges is:

Answer Answers (1)

Engineering

What is fouling on surfaces in heat exchangers, and describe how to determine the overall heat transfer coefficient for a heat exchanger?

Answer Answers (1)

Engineering

The "Crawler" developed to transport the Saturn V launch vehicle from the assembly building to the launch pad is the largest land 6 vehicle ever built, weighing 4.9 x 10 - Ibs at sea level. a - What is its mass in slugs? b - What is its mass in kilograms?

Answer Answers (1)