How should you set the OHMS ADJust control on a multitester of analog VOM, for resistance measurements?

Question

Logan Li

Computers & Technology

3 September, 12:33

How should you set the OHMS ADJust control on a multitester of analog VOM, for resistance measurements?

+1

Answers (1)

Know the Answer?

Sydney Simon · Answer 1

In my day (my next door neighbor was a brontosaurus rex), there was a wheel on the front panel.

You shorted the input leads when the master switch was turned to ohms. Then you adjusted the wheel so that the meter read 0 on the right hand side of the scale. The zero is clearly marked. The ohmmeter on an analog Vom reads 0 on the right. Everything else has its zero on the left.