An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component. (C) materials, finishes, machining operations, and dimensions of a component. (D) cost, materials, tolerances, and lead-time for a component. (E) cost, dimensions, and machining operations for a component.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
If an object with 1600 lb of weight is to be raised vertically from ground level to 5 ft in two seconds, how much power is required?
Answers (1)
Motor control circuit conductors that extend beyond the motor control equipment enclosure shall have short- circuit and ground-fault protection sized not greater than percent of the value specified in Table 310.15 (B) (16) for 602 C conductors. O a.
Answers (1)
Regeneration can only increase the efficiency of a Brayton cycle when working fluid leaving the turbine is hotter than the working fluid leaving the compressor a. TRUE b. FALSE
Answers (2)
What is the subtotal for the building materials in the bill? The subtotal should be the cost of the materials only. Don't add taxes or subtract any discounts.
Answers (1)
A room with dimensions of 3 x 10 x 20 m is estimated to have outdoor air brought in at an infiltration rate of 1/4 volume changes per hour. Determine the infiltration rate in m^3/s.
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)