A signal suspected to be of the nominal form y (t) = 5 sin 1000 mV is measured by a first-order instrument having a time constant of 100 ms and K 1 V/V. It is then to be passed through a second-order amplifier having a K = 100 V/V, a natural frequency of 15,000 Hz, and a damping ratio of 0.8. What is the expected form of the output signal, y (t) ? Estimate the dynamic error and phase lag in the output. Is this system a good choice here? If not, do you have any suggestions?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “A signal suspected to be of the nominal form y (t) = 5 sin 1000 mV is measured by a first-order instrument having a time constant of 100 ms ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
A solid circular steel shaft having an outside diameter of 2.00 in. is subjected to a pure torque of T = 8380 lb-in. The shear modulus of the steel is G = 12,000 ksi. Determine the magnitude of the angle of twist in a 5.00-ft length of shaft.
Answers (1)
What are some of the symptoms of a faulty speaker?
Answers (2)
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? A. An open circuit in the heating element B. A short circuit at the terminals C. Welded contacts on the thermostat D.
Answers (1)
The volume of the riser must always be greater than the volume of the casting in order to avoid premature solidification of the riser: True or False
Answers (1)
If the head loss in a 30 m of length of a 75-mm-diameter pipe is 7.6 m for a given flow rate of water, what is the total drag force exerted by the water on this length of pipe?
Answers (1)
New Questions in Engineering
List two characteristics of computers.
Answers (1)
Which of the following elements of the CIA triad refers to maintaining and assuring the accuracy of data over its life-cycle? Confidentiality Integrity Availability Authentication
Answers (1)
According to the video, what are some of the effects of the increase in the use of automated tools for Loading Machine Operators? Check all that apply.
Answers (2)
A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.
Answers (1)
An uncharged capacitor and a resistor are connected in series to a source of voltage. If the voltage = 7.41 Volts, C = 11.5 µFarad, and R = 89.
Answers (1)