Ask Question
EngineeringEngineering
6 November, 13:37

What is the difference between the Otto and Diesel engine?

+5
Answers (1)
  1. 6 November, 13:41
    0
    Otto engine Diesel engine

    1. Works on Otto cycle 1. Works on diesel cycle.

    2. Petrol use a fuel. 2. Diesel use as a fuel.

    3. Heat addition at constant volume. 3. Heat addition at constant pressure.

    4. Light in weight 4. Heavier in weight.

    5. Low compression ratio 5. High compression ratio.

    6. Low thermal efficiency 6. high thermal efficiency.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “What is the difference between the Otto and Diesel engine? ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
The four applicants for a $40,000 loan are Robin Smith, Amari Jones, Jamie Ford and Blake Felder. Who is the youngest loan applicant? O Jamie Ford Robin Smith Amari Jones Blake Felder
Answers (1)
What does the simplify command do
Answers (1)
3. Which of the following is not a common impact wrench drive size? (A) 1/4" (B) 3/8" (C) 1/2" (D) 3/4"
Answers (1)
A phase angle in the frequency domain corresponds to a. the initial slope of the sinusoidal signal. b. the angle at which measurements should be taken for the most accurate results. c. a delay or advance in time as compared to a pure cosine wave. d.
Answers (1)
Write an application that prompts the user for a password that contains at least two uppercase letters, at least three lowercase letters, and at least one digit. Continuously reprompt the user until a valid password is entered.
Answers (1)
New Questions in Engineering
Which of the following elements of the CIA triad refers to maintaining and assuring the accuracy of data over its life-cycle? Confidentiality Integrity Availability Authentication
Answers (1)
According to the video, what are some of the effects of the increase in the use of automated tools for Loading Machine Operators? Check all that apply.
Answers (2)
A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.
Answers (1)
An uncharged capacitor and a resistor are connected in series to a source of voltage. If the voltage = 7.41 Volts, C = 11.5 µFarad, and R = 89.
Answers (1)
The convection heat transfer coefficient for a clothed person standing in moving air is expressed as h 5 14.8V0.69 for 0.15, V, 1.5 m/s, where V is the air velocity. For a person with a body surface area of 1.
Answers (1)
Home » Engineering » What is the difference between the Otto and Diesel engine?
Sign Up Forgot Password?