The lid on a pressure vessel is held down with 10 bolts that pass through the lid and a flange on the pressure vessel (similar to example 8-4, in the text). The bolts are secured with nuts under the flange. There are no washers. The thickness of the lid is 28 mm and the thickness of the flange is 28 mm. The vessel and lid are both made of steel. The vessel is pressurized to 8 MP a, and the area of the lid exposed to the pressure is 31.4e3 mm². The modulus of elasticity is 207 GPa. The chosen bolts are ISO property class 9.8 and are coarse-pitch series, M12.
Find the external load, P, on each bolted joint.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “The lid on a pressure vessel is held down with 10 bolts that pass through the lid and a flange on the pressure vessel (similar to example ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Which component stores energy as potential energy in a mechanical system?
Answers (1)
A 1-m diameter penstock is 10-km long and carries water to an impulse turbine. If the turbine/generator is 83 percent efficient, what power can be extracted if the elevation difference between the reservoir and the nozzle is 650 m.
Answers (1)
A horizontal opaque flat plate is well insulated on the edges and the lower surface. The top surface has an area of 8 m2 and it experiences uniform irradiation at a rate of 6000 W.
Answers (1)
Format of a letter
Answers (1)
Prompt the user to enter five numbers, being five people's weights. Store the numbers in an array of doubles. Output the array's numbers on one line, each number followed by one space. (2 pts) Ex:Enter weight 1:236.0Enter weight 2:89.
Answers (1)
New Questions in Engineering
The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.
Answers (1)
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)