What is the gear ratio required to drive a compressor at 150 cycles per second using a turbine that turns at 18,000 rpms?

What types of problems might an electrical engineer need to solve?

A fluid of density 1400 kg/m^3 and viscosity of 0.9 kg/m. s flows through an 80 mm diameter pipe with a velocity of 5 m/s. What type of flow exists in the pipe? Justify your answer.

The primary difference between integrated/concurrent engineering development and functional/sequential development is: Integrated development spends more money up front to order to save money in later stages.

A three-phase, Y-connected, 75MVA, 27kV synchronous generator has a synchronous reactance of 9.0/phase. Using rated MVA and voltage as the base values, determine the per-unit reactance. Then refer this per-unit value to a 100-MVA, 30kV base.

3. Consider a 10-m-long smooth rectangular tube, with a = 50 mm and b=25 mm, that is maintained at a constant surface temperature. Liquid water enters the tube at 20C with a mass flow rate of 0.01 kg/s.

There are six items to be rung up in the cash register. The first item costs $15.00. Each item after that costs an additional $2.00. (item #2 costs $17, item #3 costs $19, etc.

List and briefly describe two modern's materials needs

Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.

How are fluids distributed and transported in a fluid power system?

The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.