A certain heat pump produces 200 kW of heating for a 293 K heated zone while only using 75 kW of power and a heat source at 273 K. Calculate the COP of this device as well as the theoretical maximum COP
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “A certain heat pump produces 200 kW of heating for a 293 K heated zone while only using 75 kW of power and a heat source at 273 K. ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
This simple machine can directly utilize the wheel and axle to lift and maneuver heavy loads. A) Inclined Plane B) Lever C) Pulley D) Wedge
Answers (2)
What is the pressure drop when a liquid (viscosity = 0.001 Pa-s, density = 1000 kg/m3) flows at a rate of 40 liters/minute over a 2-cm diameter steel pipe that is 100 meters long? Effective roughness factor (k) is 0.046 mm.
Answers (1)
Answer the following questions briefly 1. Write the definitions of * Comminution and * Calcination
Answers (1)
Characterize the risk for a chronic daily exposure by the water pathway (oral) of 1.34 x 10-4 mg/kg/day of tetrachloroethylene, 1.43 x 10-3 mg/kg/day of arsenic, and 2.34 x 10-4 mg/kg/day of dichloromethane (methylene chloride).
Answers (1)
Liquid flows at steady state at a rate of 2 lb/s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. The liquid specific enthalpy at the inlet is 40.09 Btu/lb and at the exit is 40.94 Btu/lb.
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)