Ask Question
EngineeringEngineering
6 June, 15:50

Explain the difference between Superheat, Regeneration, and Reheat attributes in a Rankine power cycle.

+4
Answers (1)
  1. 6 June, 16:16
    0
    Super heat, Regeneration and reheat all are used to improve the efficiency of Rankine cycle.

    Super heat:

    In this steam heat beyond the boiling temperature of water and then allows to expand in the turbine. By doing this, there is less possibility of corrosion of turbine blade.

    Regeneration:

    In regeneration, when steam expanding in the turbine then some parts of steam bleed from this and use to heat the feed water and after this heated water supply in the boiler, by doing this the energy required is reduces and leads to improve the efficiency of Rankine cycle.

    Reheating:

    In reheating two turbine is used. One turbine is high pressure turbine and other one is low pressure turbine. First steam supply into high pressure turbine and after that steam again reheat and after that it allows to expand in low pressure turbine. By doing this work out of cycle increases and that leads to increase the efficiency of Rankine cycle.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Explain the difference between Superheat, Regeneration, and Reheat attributes in a Rankine power cycle. ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
The Reynolds number for flow over a fixed horizontal flat plate is constant throughout its length. a) True b) False
Answers (1)
Convection ovens operate on the principle of inducing forced convection inside the oven chamber with a fan. A small cake is to be baked in an oven when the convection feature is disabled.
Answers (1)
Define the difference between elastic and plastic deformation in terms of the effect on the crystal lattice structure.
Answers (1)
In remote areas, your gps devices may lose reception. It's a good idea to have a
Answers (2)
Where is a machinist most likely to work? school building farm office factory //I want to say factory?
Answers (2)
New Questions in Engineering
A car is towed into a shop with a no-start problem. The engine cranks but will not fire and run on its own power. The car has a throttle body, fuel injected gasoline engine. Technician (A) says to check for spark and fuel first.
Answers (2)
2) How many intelligences did Dr. Howard Gardner propose that each person possesses? A) 4 B) 6 C) 8 D) 10
Answers (2)
Assign courseStudent's name with Smith, age with 20, and ID with 9999. Use the printAll () member method and a separate println () statement to output courseStudents's data. Sample output from the given program: Name: Smith, Age: 20, ID: 9999
Answers (1)
Which renewable sources are growing at the fastest rate? Which renewable source is used to produce most electricity?
Answers (2)
Air is compressed in the compressor of a turbojet engine. Air enters the compressor at 270 K and 58 kPa and exits the compressor at 465 K and 350 kPa. Take the average specific heat at constant pressure (cp, avg) of air as 1.015 kJ / kg.
Answers (1)
Home » Engineering » Explain the difference between Superheat, Regeneration, and Reheat attributes in a Rankine power cycle.
Sign Up Forgot Password?