A dairy in Fresno County discharges its wastewater to a circular treatment pond. The dairy wants to expand its operations, which will increase the influent flow but not the influent concentration. What is the maximum influent flow that can be handled by the existing pond in the future without exceeding the legally allowed effluent concentration of 30 mg/L.
Data on the existing facilities and flows are shown below. The soil is sandy and there is considerable seepage. The wastewater pollutants are particulate in form and degrade with a rate constant of 0.25 d-1.
Current conditions
influent Flow = 3200 m3/d
Influent concentration = 220 g/m3
Pond effluent concentration = 22 mg/L
Pond volume = 120,000 m3
Evaporation negligible
Seepage = 1500 m3/d
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “A dairy in Fresno County discharges its wastewater to a circular treatment pond. The dairy wants to expand its operations, which will ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
Write a program that counts the number of bits equal to one in R1, and stores the result in R2. For example, if R1=x0A0C, then R2=x0004 after the program runs.
Answers (1)
Give reasons why the control of dimensional tolerances in manufacturing is important.
Answers (1)
A vacuum gauge indicates that the pressure of air in a closed chamber is 02 bar (vacuum) The pressure of the surrounding atmosphere is equivalent to 750 in of mercury The density of mercury is 13.95 g / cn and the acceleration of gravity is 9.8.
Answers (1)
Determine if each of the following statements is true or false: 1. Larger atoms are better nucleophiles due to polarizability. 2. The identity of the nucleophile affects the rate of an SN1 reaction. 3. SN2 reactions proceed via frontside attack. 4.
Answers (2)
What is the viscosity of air at a pressure of 100 kPa and a temperature of 5°C and at 100°C?
Answers (1)
New Questions in Engineering
Work done by a system during a process can be considered as a property of the system. a) True b) False
Answers (1)
When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.
Answers (2)
hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.
Answers (1)
10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both
Answers (2)
What is the definition of diameter pitch?
Answers (1)