Ask Question
EngineeringEngineering
5 May, 23:06

Just-in-time delivery is not an important component of Lean manufacturing. a) - True b) - False

+3
Answers (1)
  1. 5 May, 23:32
    0
    False

    Explanation:

    Just-in-time manufacturing means that production is done when there is demand. It is a pull system which means that demand dictates production. Lean manufacturing is method of production which aims to reduce the seven types of waste which are

    Logistics

    Inventory

    Motion of objects during manufacturing

    Unnecessary delay

    Producing more than demand

    Over Processing of goods

    Malfunctioning items.

    Here it can be seen that Producing more than demand is a waste. This can be reduced by Just in Time manufacturing.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Just-in-time delivery is not an important component of Lean manufacturing. a) - True b) - False ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
What is the average speed of a car that travels 80km in 1.5 hours
Answers (2)
A 600 MW coal-fired power plant has an overall thermal efficiency of 38%. It is burning coal that has a heating value of 12,000 Btu/lb, an ash content of 5%, a sulfur content of 3.0%, and a CO2 emission factor of 220lb/million Btu.
Answers (1)
Technician A says that horsepower equals the ability to perfoem work at a rate of 33,000 foot-pounds per minute. Technician B says that in many vehicles, as little as 15% of the potential energy in the fuel is delivered to the drive wheela.
Answers (1)
Welding never causes residual stresses in the work piece, which may result in distortion stress corrosion cracking, and reduced fatigue life. (True / False)
Answers (1)
Tech A says never use a water hose to clean up dust after a repair. Tech B says never use a floor scrubber to clean up dust after repairs. Who is correct?
Answers (1)
New Questions in Engineering
The pressure and temperature at the beginning of compression of an air-standard Diesel cycle are95 kPa and 300 K, respectively. At the end of the heat addition, the pressure is 7.2 MPa and thetemperature is 2150 K.
Answers (1)
Explain two Types of bearing?
Answers (1)
7 Single-use earplugs require a professional fitting before they can be used. A True B) False
Answers (2)
Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.
Answers (1)
When the French horn plays with brass instruments, then it is played very softly to match the texture. True/False
Answers (1)
Home » Engineering » Just-in-time delivery is not an important component of Lean manufacturing. a) - True b) - False
Sign Up Forgot Password?