Engineering

11 April, 09:07

It is a common trick to fill a straw with water, put your finger on the top of straw, and then watch as the water is suspended within the straw.

Assuming that water has a density of 1000 kg/m^3 and the atmospheric pressure is 101 kPa, then estimate the pressure (kPa) of the air inside of the straw at the top of water column. Neglect any surface tension effects.

+4

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question 👍 “It is a common trick to fill a straw with water, put your finger on the top of straw, and then watch as the water is suspended within the ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.

Search for Other Answers

You Might be Interested in

What is the subtotal for the building materials in the bill? The subtotal should be the cost of the materials only. Don't add taxes or subtract any discounts.

The two-stroke engine is a) simple and expensive c) low power-to-volume ratio b) high power-to-weight ratio d) all of the mentioned

Which of the following bonding is the strongest? (a) lonic bonding (b) Metallic bonding (c) Covalent bonding with some van der Waals bonding (d) van der Waals bonding

Calculate the resulting power factor if a synchronous motor rated at 500 hp with 90% efficiency operating at rated load and at unity power factor is added to the plant instead of the capacitor. Assume constant voltage (1 hp = 0.746 kW).

Which one of the following activities is not an example of incident coordination

New Questions in Engineering

The Reynolds number, rhoVD/μ is a very important parameter in fluid mechanics. Determine its value for ethyl alcohol flowing at a velocity of 4 m/s through a 2-in.-diameter pipe.

Work done by a system during a process can be considered as a property of the system. a) True b) False

When the compression process is non-quasi-equilibrium, the molecules before the piston face cannot escape fast enough, forming a high-pressure region in front of the piston. It takes more work to move the piston against this high-pressure region.

hypothetical A-B alloy of composition 40 wt% B-60 wt% A at some temperature is found to consist of mass fractions of 0.66 and 0.34 for the α and β phases, respectively.

10. Which of these requires a wheel alignment after replacement? A. Struts B. Shocks C. Both