What standard feature is on all circular saws?

1. Blade guard

2. Blade-height adjustment

3. Angle-of-cut adjustment

4. All of the above

In a piece of aluminum you want to make a pocket (milling of cavities), an end mill tool of 6 mm in diameter and 4 cutting sides will be used, the height of the cutting sides of the tool is 25 mm. The feed that will be taken per tooth will be 0.

What do you think are the sources of the information Jim and his team collected? How do you think they collected all of that information?

Considere uma estufa usada em um laboratório qualquer. A câmara tem formado de um cubo perfeito com lado igual a 75 cm, desse modo deseja-se saber qual a espessura mínima requerida do isolante térmico de espuma de poliestireno (K = 0,025 W / m.

cThe Mars Rover Spirit got stuck in the Martian sand. The wheels kept slipping. Attempts to free it were futile. Discuss the type of actuator in this case.

2. Wheel grinders need be equipped with a (n) :

List and briefly describe two modern's materials needs

Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.

How are fluids distributed and transported in a fluid power system?

The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.

Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers