Ask Question
EngineeringEngineering
17 March, 16:57

Why should a toolpath be verified on the screen of a CAM system prior to creating the program code?

+2
Answers (1)
  1. 17 March, 17:15
    0
    The tool's trajectory in a CAM program refers to the places where the tool will be during the work. It is important to review it before generating the program for the following reasons

    1. analyze the machining strategy and identify which one is better for each piece.

    2. Avoid the collision of the tool holder with the work piece.

    3. Avoid the shock of the tool with the piece.

    4. Prevent the collision of the tool with elements that are not displayed on the CAM such as clamping flanges or screws.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question 👍 “Why should a toolpath be verified on the screen of a CAM system prior to creating the program code? ...” in 📗 Engineering if the answers seem to be not correct or there’s no answer. Try a smart search to find answers to similar questions.
Search for Other Answers
You Might be Interested in
problem 3.49 Determine the maximum mass of the crate so that the tension developed in any cable does not exceeded 6.6 kN
Answers (1)
There are 20 forging presses in the forge shop of a small company. The shop produces batches of forgings requiring a setup time of 3.0 hours for each production batch.
Answers (1)
How does Cesca show that she has learned these lessons?
Answers (1)
An architect-engineering firm is planning a parking lot to accommodate 500 vehicles. Each parking space will be 8 feet times 13.5 feet. It has been estimated that the space required for aisles will be 85 % of the space required for parking.
Answers (1)
What is the initial state of the compression process of your car?
Answers (1)
New Questions in Engineering
List and briefly describe two modern's materials needs
Answers (1)
Write the definition of a method named add that receives a reference to a Scanner object associated with a stream of input consisting of integers only. The method reads all the integers remaining to be read from the stream and returns their sum.
Answers (1)
How are fluids distributed and transported in a fluid power system?
Answers (1)
The sliders A and B are connected by a light rigid bar of length l = 20 in. and move with negligible friction in the slots, both of which lie in a horizontal plane. For the position where xA = 16 in., the velocity of A is vA = 3 ft/sec to the right.
Answers (1)
Two parallel Rivers (A and B) are separated by confined and unconfined aquifer estimate the RATE of seepage of river A to River B per unit length of the rivers
Answers (1)
Home » Engineering » Why should a toolpath be verified on the screen of a CAM system prior to creating the program code?
Sign Up Forgot Password?